Eaton 9A UPS - Page 23

15
9A UPS 1-3K
B-Installaon
Installaon in rack posion
Follow steps 1 to 4 for module mounng on the rails.
1. Aach rail on the back of the rack.
2. Aach the rail on the front of the rack using the two holes at the boom.
3. Aach the mounng kit plate to the UPS.
4. Place the UPS on the rails and x the mounng plate to the top hole of the rail.
The rails and necessary hardware are supplied by Eaton.
1
2
3
9A
4
9A