Eaton 9A UPS - LCD Description

18
9A UPS 1-3K
4.2 LCD descripon
In order to make sure all segments are OK, LCD begins to do self-test aer power on. During
self-test, all the segments will be lighted for 2 seconds, then the LCD will turn to normal
display status.
The following table describes the LCD display informaon provided by the UPS:
LCD display Descripon
Mode/Fault/Warning Informaon
It Indicates the operang mode or Fault kind or Warning kind, several
warning kinds at the same me could be displayed alternately.
Input Informaon
It indicates input voltage/frequency value, which are displayed alternately.
Baery Informaon
It indicates the baery capacity. Every grid represents the capacity of 20%.
Seng indicaon
It indicates the UPS is in seng mode.
Fault indicaon
It indicates the UPS is in Fault mode or has some warnings.
Load Informaon
It indicates the load level. Every grid represents the level of 20%.
Output Informaon
It indicates output voltage/frequency value, which are displayed alternately.
Hz
Vac
Hz
Vac
+
OUTPUT LOAD
INPUT BATTERY
Mode/Fault/Warning







Hz
Vac
INPUT
+
BATTERY
LOAD
Hz
Vac
OUTPUT