Eaton 9A UPS - UPS Specifications; Electrical Input and Output Specs

27
9A UPS 1-3K
5.3 UPS shutdown
To shut down the UPS:
Press the “OFF” buon on the front panel for more than 1 seconds. The UPS will get into no
output or bypass mode. At this me, the UPS might has output if bypass is enable.
Disconnect the ulity power to turn o the output.
5.4 Test funcon
Real me detecon
UPS could do real-me detecon when baery connected or disconnected. If the baery
connecon status is changed, in oang mode, UPS will detect the change within 30 sec-
onds; in resng mode, UPS will detect the change within 3 minutes.
Manual test
Test the funcon of the UPS system by pressing the On-Switch for more than 1 second, the
UPS would detect whether the baery is connected or the baery is low immediately. Also
the UPS could do the test automacally and periodically, the period me could be set by
user, the default value is 7 days.
5.5 Audible alarm mute funcon
• If the alarm is too annoying in baery mode, you may press “ON” buon connuously for
more than 1 second to clear it. Moreover, the alarm will be enabled when the baery is
low to remind you to shutdown the load soon.
• If the alarm is too annoying in bypass mode, you may press “OFF” buon connuously
for more than 1 second to clear it. The acon doesn’t aect the warning and fault alarm.
• If all alarm is too annoying, you can short touch “ON” buon, all alarms are disable, if
alarms need to be resumed, short touch “ON” buon again.