Eaton 9A UPS - Ebm Rack 1-3 Kva

14
9A UPS 1-3K
C-UPS Connecon
!
Check that the indicaons on the name plate located on the top of the UPS meets
to the AC-power source and the true electrical consumpon of the total load.
1. For 9A1000IR and 9A2000IR connect the UPS input socket
① to the AC-power source
using the cable of the protected equipment. For 9A3000IR connect the cable
(250V-16A) to
the socket
①, then to the AC- power source.
2. Connect the loads to the UPS using the cables
②.For 9A3000IR model, connect high-pow-
er devices to the 16A outlet
③.
Note: The UPS charges the baery as soon as it is connected to the AC-power
source, even if “ON” buon is not pressed.
Once the UPS is connected to the AC-power source, 24 hours of charging are required
before the baery can supply the rated backup me.
3.5 EBM RACK 1-3KVA
A-Checking the accessory kit
3
1
2
9A
EBM
Moun�ng kit for 19-inch
enclosures
Instruc�ons and Safety
Informa�on
Quick start
Rack kit for 19-inch 4-post
enclosures
1
3
5
4
2
1
2
3
4
5