Eaton Cutler-Hammer FP-5000 - Page 78

IL17569
Page 5-30
Effective June, 2001
Table 5.8 Clock
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
Clock Time and Date 5.5.8
Date mode: Select date format MM/DD/YY or DD/MM/YY 0 5.5.8
Time mode: Select standard time 12 or 24 12 5.5.8
or military time
Year: Select year 0 to 99 0 5.5.8
Month: Select month 1 to 12 1 5.5.8
Day: Select Day 1 to 31 1 5.5.8
Hour: Select hour (set in 24 hour mode) 0 to 23 0 5.5.8
Minute: Select minute 0 to 59 0 5.5.8
Second: Select Seconds 0 to 59 0 5.5.8
Update Clock! Press the “Enter” pushbutton
after setting clock to update the clock
Table 5.9 Communications
Display Setting Description Setpoint Range/ Default Selected Refer to
Value Selection Setting Value Sec. #
INCOM INCOM Communications Settings 5.5.9
Enable: Enable INCOM communications Yes or No Yes 5.5.9
Address: Select Communication address 1 to 0xFFE (Hex Value - 1 5.5.9
of FP5000 increments of 1)
Baud rate: Baud rate fixed at 9600 baud Fixed at 9600 Baud 9600 5.5.9
Accessory Bus Accessory Bus Address 5.5.9
and Baud rate setting
Address: Select Communication address 1 to 0xFFE (Hex Value - 2 5.5.9
of FP5000 increments of 1)
Baud rate: Baud rate fixed at 9600 baud Fixed at 9600 Baud 9600 5.5.9
RS-232 RS-232 Baud Rate Setting 5.5.9
Baud rate: Select baud rate 9600, 19200, 19200 5.5.9
for RS-232 communications or 38400 Baud