EDR-5000 IM02602007E
Communication Protocols
Module: SCADA
Comm
Device Planning Parameters of the Serial SCADA Interface
Parameter Description Options Default Menu path
Protocol CAUTION! Changing the protocol will cause a
restart of the device
Do not use,
Modbus RTU,
Modbus TCP,
DNP RTU,
DNP TCP,
DNP UDP,
IEC61850,
Profibus
Do not use [Device Planning]
Signals (Output States) of the SCADA Interface
Signal Description
Comm connected At least one Communication system is connected to the device.
Comm not connected No Communication system is connected to the device.
www.eaton.com 254
To Next Page
Loading...
