EDR-5000 IM02602007E
Application Example Setting a Relay:
Binary Output signals of the DNP cannot directly be used in order to switch relays because the DNP Binary Outputs are
pulse signals (by DNP definition, not steady state). Steady states can be created by means of Logic functions. The
Logic Functions can be assigned onto the Relay Inputs.
Please note: You can use a Set/Reset element (Flip Flop) from Logics.
www.eaton.com 311
RO
Signal Set Relay
Signal Reset Relay
Pulse Signal
Pulse Signal
Logic
Assign Logic Functions onto Relay Inputs
>1
OR
>1
OR
To Next Page
Loading...
