Eaton EDR-5000 - Page 379

EDR-5000 IM02602007E
To change additional parameters and save afterwards,
move to other parameters and change them
A star symbol in front of the changed parameters indicates that the
modifications have only been saved temporarily, they are not yet finally
stored and adopted by the device.
In order to make things easier to follow, especially where complex
parameter changes are involved, on every superior/higher-ranking menu
level the intended change of the parameter is indicated by the star symbol
(star trace). This makes it possible to control or follow up from the main
menu level at any time where parameter changes have been made and have
not been saved finally.
In addition to the star trace to the temporary saved parameter changes, a
general parameter changing symbol is faded-in at the left corner of the
display, and so it is possible from each point of the menu tree to see that
there are parameter changes still not adopted by the device.
Press the »OK« key to initiate the final storage of all parameter changes. Confirm the parameter changes by pressing
the »Yes« softkey or dismiss by pressing Softkey »No«.
If the display shows a Key Symbol instead of a Wrench-Symbol, this will
indicate, that the required access authorization is not available.
In order to edit this parameter, a password is required, that provides the
required authorization.
www.eaton.com 379