Eaton EDR-5000 - Page 403

EDR-5000 IM02602007E
Current protective functions cannot only be blocked permanently (»F unction = Inactive« ) or temporarily by any blocking
signal from the »Assignment list«, but also by »Reverse Interlocking« .
All other protection functions can be activated, deactivated, or blocked in the same manner.
www.eaton.com 403
AND
Inactive
Active
Name.Rvs Blo Fc
AND
Inactive
Active
Name.Func tion
Inactive
Active
Name.ExBlo Fc
Name.A ctive
Prot. Active
1..n, Assignment List
Name.ExBl o 1
1..n, Assignment List
Name.Rvs Blo
Nam e .ExBlo
Name .Rvs Blo
Blockings **
(The G eneral Protection module is not deactivate d or blocke d)
Name
= I[1]...[n], IG[1]...[n]
Nam e.ExBlo1-I
Name.Rvs Blo-I
1..n, As signment List
Name.ExBlo 2
Name.ExBlo 2-I
1
4
Please Refer to Diagram:
P rot
OR
AND
*
All protective elements will be blocked that are using fundamentals or harmonic measured values , i f the frequency leaves the nominal frequency range. Pr otective elements that are using RMS values will remain active. See chapter "Wi de frequency range".
* *
This applies to devices that offer wide frequency range measurement onl y.
Frequency is within the nominal frequenc y range.
( *) (**)