Eaton EDR-5000 - Page 431

EDR-5000 IM02602007E
Parameter Description Setting range Default Menu path
Trigger44 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger45 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger46 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger47 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger48 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger49 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Trigger50 Open Command to the Breaker if the state of the
assigned signal becomes true.
1..n, Trip Cmds -.- [Control
/Bkr
/Trip Manager]
Synchronizm Synchronizm 1..n, In-SyncList -.- [Control
/Bkr
/Synchron Switchg]
t-MaxSyncSuperv Synchron-Run timer: Max. time allowed for synchronizing
process after a close initiate. Only used for
GENERATOR2SYSTEM working mode.
0 - 3000.00s 0.2s [Control
/Bkr
/Synchron Switchg]
t-Move CLOSE Time to move to the CLOSE Position 0.01 - 100.00s 0.1s [Control
/Bkr
/General Settings]
t-Move OPEN Time to move to the OPEN Position 0.01 - 100.00s 0.1s [Control
/Bkr
/General Settings]
www.eaton.com 431