Eaton EDR-5000 - Page 651

EDR-5000 IM02602007E
Parameter Description Setting range Default Menu path
MinLiveLineVoltage Minimum Live Line voltage (Live line detected, when line
voltage above this limit.)
0.10 - 1.30Vn 0.65Vn [Protection Para
/<1..4>
/Sync-check
/DeadLiveVLevels]
MaxDeadLineVoltag
e
Maximum Dead Line voltage (Dead Line detected, when
line voltage below this limit.)
0.01 - 1.00Vn 0.03Vn [Protection Para
/<1..4>
/Sync-check
/DeadLiveVLevels]
t-VoltDead Voltage dead time (A Dead Bus/Line condition will be
accepted only if the voltage falls below the set dead
voltage levels longer than this time setting)
0.000 - 300.000s 0.167s [Protection Para
/<1..4>
/Sync-check
/DeadLiveVLevels]
MaxVoltageDiff Maximum voltage difference between bus and line
voltage phasors (Delta V) for synchronizm (Related to
bus voltage secondary rating)
0.01 - 1.00Vn 0.24Vn [Protection Para
/<1..4>
/Sync-check
/Conditions]
MaxSlipFrequency Maximum frequency difference (Slip: Delta f) between
bus and line voltage allowed for synchronizm
0.01 - 2.00Hz 0.20Hz [Protection Para
/<1..4>
/Sync-check
/Conditions]
MaxAngleDiff Maximum phase angle difference (Delta-Phi in degree)
between bus and line voltages allowed for synchronizm
1 - 60° 20° [Protection Para
/<1..4>
/Sync-check
/Conditions]
DBDL Enable/disable Dead-Bus AND Dead-Line synchronizm
overriding
Inactive,
Active
Inactive [Protection Para
/<1..4>
/Sync-check
/Override]
DBLL Enable/disable Dead-Bus AND Live-Line synchronizm
overriding
Inactive,
Active
Inactive [Protection Para
/<1..4>
/Sync-check
/Override]
LBDL Enable/disable Live-Bus AND Dead-Line synchronizm
overriding
Inactive,
Active
Inactive [Protection Para
/<1..4>
/Sync-check
/Override]
www.eaton.com 651