Eaton EDR-5000 - Page 899

EDR-5000 IM02602007E
States of the Inputs of the Failure Simulator
Name Description Assignment via
Ex Start Simulation-I State of the module input:External Start of Fault Simulation (Using
the test parameters)
[Service
/Test Mode (Prot inhibit)
/WARNING! Cont?
/Sgen
/Process]
ExBlo Module Input State: External Blocking [Service
/Test Mode (Prot inhibit)
/WARNING! Cont?
/Sgen
/Process]
Ex ForcePost-I State of the module input:Force Post state. Abort simulation. [Service
/Test Mode (Prot inhibit)
/WARNING! Cont?
/Sgen
/Process]
Signals of the Failure Simulator (States of the Outputs)
Signal Description
Running Signal: Measuring value simulation is running
State Signal: Wave generation states: 0=Off, 1=PreFault, 2=Fault, 3=PostFault, 4=InitReset
www.eaton.com 899