Eaton EDR-5000 - Page 990

EDR-5000 IM02602007E
Name Description
UFLS.AdaptSet5-I Module Input State: Adaptive Parameter5
ZI.Active Signal: Active
ZI.ExBlo Signal: External Blocking
ZI.Blo TripCmd Signal: Trip Command blocked
ZI.ExBlo TripCmd Signal: External Blocking of the Trip Command
ZI.Bkr Blo Signal: Blocked by Breaker Failure
ZI.Phase Pickup Signal: Zone Interlocking Phase Pickup
ZI.Phase Trip Signal: Zone Interlocking Phase Trip
ZI.Ground Pickup Signal: Zone Interlocking Ground Pickup
ZI.Ground Trip Signal: Zone Interlocking Ground Trip
ZI.Pickup Signal: Pickup Zone Interlocking
ZI.Trip Signal: Zone Interlocking Trip
ZI.TripCmd Signal: Zone Interlocking Trip Command
ZI.Phase OUT Signal: Zone Interlocking Phase OUT
ZI.Ground OUT Signal: Zone Interlocking Ground OUT
ZI.OUT Signal: Zone Interlocking OUT
ZI.IN Signal: Zone Interlocking IN
ZI.ExBlo1-I Module Input State: External Blocking1
ZI.ExBlo2-I Module Input State: External Blocking2
ZI.ExBlo TripCmd-I Module Input State: External Blocking of the Trip Command
SOTF.Active Signal: Active
SOTF.ExBlo Signal: External Blocking
SOTF.Rvs Blo Signal: Reverse Blocking
SOTF.enabled Signal: Switch Onto Fault enabled. This Signal can be used to modify Overcurrent Protection Settings.
SOTF.AR Blo Signal: Blocked by AR
SOTF.I< Signal: No Load Current.
SOTF.ExBlo1-I Module Input State: External Blocking
SOTF.ExBlo2-I Module Input State: External Blocking
SOTF.Rvs Blo-I Module Input State: Reverse Blocking
SOTF.Ext SOTF-I Module Input State: External Switch Onto Fault Alarm
CLPU.Active Signal: Active
CLPU.ExBlo Signal: External Blocking
CLPU.Rvs Blo Signal: Reverse Blocking
CLPU.enabled Signal: Cold Load enabled
CLPU.detected Signal: Cold Load detected
CLPU.AR Blo Signal: Blocked by AR
CLPU.I< Signal: No Load Current.
www.eaton.com 990