Eaton i-on16 - 2. Alarms

i-on16
Page 13
2. Alarms
The table below shows the different kinds of alarms possible.
Type of
Alarm
Signal
(see note)
Started by:
Intruder
Loud warbling
tone from siren.
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire
Pulsing tone
from siren.
Fire zone activated at any time.
Hold Up
Loud warbling
tone from siren
HUA zone or radio Hold Up Alarm
transmitter activated at any time.
Pressed on keypad.
(The installer must enable this feature on
your system.)
Tamper
Loud warbling
tone from siren
Some part of the alarm system has been
opened (tampered with).
An alarm system cable has been cut or
shorted.
An incorrect user code has been entered
too many times.
Technical
Quiet beeping
once per second
from keypads.
Technical alarm zone activated at any
time.
Fault
Quiet beeping
once per second
from keypads.
A system fault detected by the control
unit, for example, mains failure, or
communications line fault. See page 17.