Eaton i-on16 - Deleting Users

i-on16 4. Administration
Page 47
The display finally asks you to
press both buttons on any radio
HUD that you want to assign to the
new user.
13. Press both buttons on a radio HUD
that you wish to assign to the user.
If you do not have one for the user
press .
Note: A Duress user cannot have a
remote control or radio HUD.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows that the new user
has been added to the system.


Followed by:


To add another user to the system repeat steps 5 to 13.
Otherwise, press  repeatedly to leave the Menu and save your changes.
Deleting Users
You must be a Master user to delete a user, see page 34. To delete a user:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  .


5. Press .


6. Press  until you see:


7. Press .
The bottom line of the display
shows the first user in a list of the
users recognised by the system.

