Eaton i-on16 - Deleting Remote Controls

4. Administration i-on16
Page 74
“Off” = Turns the output off.
“Toggle” = Changes the state of
the output every time you press
the button.
14. Press  or . until the display
shows the action you want to give
to the button, for example:


15. Press  .
The keypad gives a double
“beep” confirmation tone. The
keypad display shows:


16. Press  repeatedly to leave the
menu.
Repeat steps 8 to 15 if you want
to program any more remotes.
17. Press  repeatedly to leave the
menu.
Deleting Remote Controls
If a user has lost a remote control you should delete it from the system to
make sure that no unauthorised person can use it to gain access. Also, if
you wish to reassign a device to another user, you must first delete it from
the system.
To delete a single remote:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .

