Eaton i-on16 - Turning Outputs On;Off

i-on16 4. Administration
Page 81
Turning Outputs On/Off
You can operate the outputs from the keypad, as well as by using a remote
control (provided the installer has assigned some outputs to you). To
operate an output:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows the first in a list
of the outputs that are available to
you.
Note that the outputs may be
programmed with a name, for
example “PORCH LIGHT”.


6. Press  until the display shows the
output you wish to operate:


7. Press  to change the state of the
output.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:
Note: Outputs connected to radio output
modules may take several seconds to
change state.


9. Press .
The display returns to the “Outputs
On/Off” menu, and the control unit
operates the selected output.

