Eaton i-on16 - Remotes and Two-Way Keyfobs

i-on16 4. Administration
Page 57
Remotes and Two-way Keyfobs
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows:


6. Press  until you see:


7. Press .
The display asks you to press any
button on the remote or two-way
keyfob you wish to test.


If there are no remotes or two-way
keyfobs available the display briefly
shows:


8. Press a button on the device you
wish to test (you should press and
hold the button down until the
transmit LED on the device
flashes).
The keypad gives a double “beep”
confirmation tone.
The top line of the display shows:
the number of the device, the
button you pressed, and the user
the device is allocated to.
The bottom line of the display
shows the function of the button
you pressed and the strength of the
signal received by the system from

