Eaton i-on16 - Programming Outputs

4. Administration i-on16
Page 58
the remote. If the signal strength is
less than 4 you should contact your
installer.
a). Press all the other buttons on the
device.
Each time you press a button on the
remote the keypad gives a double
“beep” confirmation tone.
For each button you press you will see
a similar message, for example:


b) Press a button on any other device
that you wish to test.
The keypad gives a double “beep”
confirmation tone.
The display shows information for any
device allocated to a user of the
system, for example:


9. Press  to end the test.


Radio Hold Up Alarms
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows:


6. Press  until you see:


7. Press .