Eaton i-on16 User Manual

4. Administration i-on16
Page 62
9. Press  to start the call.
The display shows the progress of
the call.
Check with the person asking for
the test that the test call has
succeeded. If the call fails the
display will show “Call failed”
followed by a short message about
the reason for the failure.


System Configuration
The System Configuration option allows you to change some parts of the
system to suit your particular needs. If you need more extensive changes
to the operation of the system then you must contact your installer.
Switching the Chime On/Off
The installer may have set up your alarm system to give a chime tone
whenever something triggers one or more detectors while the system is
unset. If you wish to switch this feature off (or on) then:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The bottom line of the display
shows:


6. Press  .
The bottom line of the display
shows the current status of the
Chime facility: “On” means the
loudspeakers will sound a chime



Eaton i-on16 Specifications

General

Brand	Eaton
Model	i-on16
Category	Security System
Language	English