Eaton i-on16 - Using Radio Keypads and Remote Controls; Using a Radio Keypad

3. Setting and Unsetting i-on16
Page 26
How Do I Know The System Is Unset?
The keypad stops the entry tone.
The system is unset.
The keypad display shows:


followed by:


LEDs “A” to “D” should be dark,
showing that the system is unset.
Note: The installer may have disabled
the LEDs to ensure that the
alarm system meets the
appropriate standards.
Using Radio Keypads and Remote
Controls.
Using a Radio Keypad
Setting
Secure all your windows and doors. Make sure the system is idle, and that
you can hear the warning tones from the sounders.
1. Key in a valid access code (or present your proximity tag).
2. Press either A, B, C or D to set the portion of system that you require.
(If you wish to stop setting while the exit tone sounds, then press .)
The left hand LED glows to show that the keypad is transmitting.
3. Complete setting using the method programmed by the Installer (see
“3. Finishing Setting” on page 20).