Eaton i-on16 - Starting a Test Call

i-on16 4. Administration
Page 61
The bottom line of the display
shows the users owning each prox
tag, for example:
If the control unit does not
recognise a prox tag, the display
shows:


9. Press  to end the test.


Starting a Test Call
If your control unit has a suitable communications module fitted then the
Installer or the Alarm Receiving Centre may ask you to start a test call. This
could be in order to check that the control unit and communications module
are working correctly or to help clear a communications alert. Your control
unit will have two pre-programmed telephone numbers. When the Installer
or ARC ask you to make a test call they will tell you which number to use.
To make a test call:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .
The display shows:


6. Press  until you see:


7. Press .
The display shows the first of two
telephone numbers that the control
is already programmed to call.


8. Press  or  to select the phone
number you have been asked to
test.

