Eaton i-on16 - Page 36

3. Setting and Unsetting i-on16
Page 30
What Happens if the System Will Not Set
Press and
hold:
The setting LED flashes red three times.
The system tries to set. If there is a fault
(for example a door open) then the control
unit sends a message to the fob to say that
it cannot set.
All four LEDs glow red for three seconds.
Querying the State of the System
Press and
hold:
The query LED flashes red three times.
The control unit send a message to the fob
giving the current state of the system. If the
system is:
Full Set, you see a green Set LED:
Part Set, you see a green Part Set LED:
Unset, you see a green Unset LED: