Eaton M-Max series - Page 56

M-Max Series adjustable frequency drive
46 For more information visit: www.eaton.com
MN04020002E
February 2010
Table 11: All Parameters (continued)
PNU ID
Access
Right
RUN Designation Value Range
Factory
Setting
User
Setting
User Set
S4.1 830 — Display contrast 0 – 15 7
S4.2 831 — Factory setting
(WE)
0 = Retain current values
1 = Clears all values and restores
default settings
0
S4.3 832 — Password 0
Display Values
M1.1 1 — Output
frequency
Hz 0.00
M1.2 25 — Frequency
reference value
Hz 0.00
M1.3 2 — Motor shaft
speed
rpm (calculated value, rpm) 0
M1.4 3 — Motor current A 0.00
M1.5 4 — Motor torque % (calculated value) 0.0
M1.6 5 — Motor power % (calculated value) 0.0
M1.7 6 — Motor voltage V 0.0
M1.8 7 — Intermediate DC
bus voltage
V 0.0
M1.9 8 — Unit temperature ˚C 0
M1.11 13 — Analog input 1 % 0.0
M1.12 14 — Analog input 2 % 0.0
M1.13 26 — Analog output 1 % 0.0
M1.14 15 — Digital input 1 – 3 DI1, DI2, DI3 status 0
M1.15 16 — Digital input 4 – 6 DI4, DI5, DI6 status 0
M1.16 17 — Digital output RO1, RO2, DO status 1
M1.17 20 — PID reference
value
% 0.0
M1.18 21 — PID feedback % 0.0
M1.19 22 — PID error value % 0.0
M1.20 23 — PID output % 0.0
M1.21 1479 — Pulse counter
value
— 0.0
Parameters marked with "M" (Monitor) are values currently being measured, variables
calculated from these measured values, or status values from control signals.
They cannot be edited.