Eaton Powerware 9125 - UPS Rear Panels

EATON Powerware
®
9125 (9910-E30) UPS Installation Guide for IBM
®
Applications S 164201696 Rev 1
31
Chapter 2 Operation
This section describes:
S Turning the UPS on and off
S Starting the UPS on battery
S Initiating the self-test
S Operating modes
Turning the UPS On
After the UPS is connected to a power outlet, it conducts a self-test and
enters S tandby mode.
To turn on the UPS, press the On
button on t he front panel. The
μ
indicator illuminates solid and the bar graph indicators display the
percentage of load being applied to the UPS.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the
On
button for at least four seconds. The UPS supplies power to your
equipment and goes into Battery mode. When the UPS starts on
battery, it does not conduct a self-test to conserve battery power.