OPERATION
EATON Powerware
®
9125 (9910-E30) UPS Installation Guide for IBM
®
Applications S 164201696 Rev 1
37
Configuration M ode
When the UPS is in Configuration mode, the bar graph indicators
represent the configuration options. Use the control buttons
(On
button and button) to modify the UPS configuration. Figure 38
shows t he LEDs and Table 13 explains the corresponding options.
NOTE The UPS can be configured while in Battery mode. If the UPS transfers to battery
power while in Configuration mode, the UPS remains in Configuration mode and indicates
Battery mode on the front panel.
1. Press the On button and the button simultaneously for one
beep. The UPS transfers to Configuration mode.
The bar graph indicators flash briefly and then display the enabled
options.
2. Press the On
button to scroll through the options. Each time you
press t he button, the UPS beeps. The LED for the selected option
indicates the current setting; flashing represents disabled options
(see Figure 38 and Table 13).
If you press the On
button and nothing happens, t he UPS is still in
Operation mode. Repeat Step 1 t o enter Configuration mode, and
then perform Step 2.
3. Press the
button ONCE to toggle the selected option on or off.
Repeat Steps 2 and 3 for each option. Scrolling past the last LED
returns t o the first configuration option.
NOTE The UPS exits Configuration mode automatically after two minutes of inactivity.
4. Press the On button and the button simultaneously to exit
Configuration mode at any t ime.
To Next Page
Loading...
