Eaton Powerware 9125 - Load Segments

COMMUNICATION
EATON Powerware
®
9125 (9910-E30) UPS Installation Guide for IBM
®
Applications S 164201696 Rev 1
48
p5 or pSeries with Logical Partitions Interface Overview
To connect the UPS to a p5 or pSeries with LPARs you need:
S An Eaton-supplied ConnectUPS-X Web/SNMP Card, located in the
FC 2934 carton labeled “ConnectUPS-X Web/SNMP Card Kit”
S NetWatch software from the Software Suite CD, located in the E 30
accessory kit
S A customer-supplied Ethernet cable
S An available Ethernet port on the server
Follow the instructions included with the ConnectUPS-X Web/SNMP
Card Kit to install the card and set UPS monitoring functions. Installation
may include removal of an existing X-Slot card from the UPS.
Follow the software installation instructions contained on the Software
Suite CD to install the NetWatch software onto each LPAR.
Connect the Ethernet cable as shown in Figure 45.
Ethernet Connectors ConnectUPS-X Web/SNMP Card
UPS
Ethernet Cable
(customer-supplied)
IBM p5 Server
The server must have
an available E thernet port.
Figure 45. p5 or pSeries with LPARs Interface