48 S611 Soft Starter MN03902011E—May 2012 www.eaton.com
Configuring the S611
Entering values for the basic protection parameters and the
advanced configuration parameters can be accomplished
directly through the User Interface Module (UI). The UI or the
Network connection may be used to configure all models of
the S611 soft starter.
Viewing and editing protection set-points can be performed
in the Protection and Operation (P/O) mode. The following
diagram outlines the procedure for modifying any of the set
points.
Note that the editing mode can be exited (without saving the
parameter) value by pressing the Mode button.
Functions that can be performed and parameters that can be
monitored include the following on the User Interface
Module (UI):
●
Mode LED Indicators—Protection, Operation, Monitor
●
Units LED Indicators—Amps, Volts, kW, User Defined
●
Phase Indicator LED Indicators—Average, Phase A,
Phase B, Phase C
●
Status LED Indicators—Ready, Fault
●
Alpha Numeric Display—Parameter values and Fault Codes
●
Function Keys—Mode/Cancel, Up, Down, Edit/Save, Fault
Log, Reset
Entering Basic Operating Parameters
Step 1: Press Mode button until Protection or Operation (P/O) mode LED is lit.
Step 2: Press Up or Down button until the desired P/O LED is lit. Display shows
the current parameter value.
Step 3: Press the Edit/Save button. The display shows the parameter value
but it is now flashing.
Step 5: Press the Edit/Save button. The display now stops flashing and shows
the new parameter value that has been saved by the device.
Mode/Cancel
120
Step 4: Use the Up/Down buttons to adjust the parameter to the desired value.
110
110
120
Edit/Save
Edit/Save
www.comoso.com
To Next Page
Loading...
