Ebyte E180-Z6907A User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd E180-Z6907A User Manual
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co., Ltd.
4-20
Return
：
FC 40 00
Return
：
FC 40 00
6.6 HEX Parameter description
6.6.1 System transmitting mode
mode：
0x00 Broadcast（default）；
0x01 (need to configure the target group number in configuration mode first);
0x02 Transparent transmission on demand + short address (need to configure the target short
address in configuration mode);
0x03 transparent transmission on demand + long address (need to configure the target long
address in configuration mode);
0x04 protocol on demand + short address (the first two bytes in the transmission mode are the
short address of the target device network);
0x05 protocol multicast (the first byte in the transmission mode is the target network group
number);
6.6.2 Receiving data output mode
mode：
0x00 transparent transmission（default)；
0x01 data+short address；
0x02 data+long address；
0x03 data+RSSI;
0x04 data+short address+RSSI；
0x05 data+long address+RSSI；
Note: the maximum package length is 72
6.6.3Network node type
dev_type：
0x03 End-device(Default)
0x04 Sleep-End-device
Changing the configuration of a node type takes effect after restart. If node type device is configured in normal
operation, it will leave the current network in a no-network state. After restart, it will switch to the changed node type.
The sleep-end-device supports the serial port receive pin wake-up function. The wake-up frame byte length is less
than or equal to 10 bytes. It is recommended to use“FF FF FF FF FF FF FF FF FF FF”10 bytes of "FF" wake up.
6.6.4 Network state
nwk_state：
0x00 No network

Ebyte E180-Z6907A Specifications

General

Brand	Ebyte
Model	E180-Z6907A
Category	Wireless modules
Language	English