EasyManua.ls Logo

Ecolab EFW5L - Page 13

Ecolab EFW5L
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 13 of 51
EFW5L_IFU REV NEW
NOTE Ut is the a.c. mains voltage prior to application of the test level.
NOTE 1 At 80MHz and 800MHz the higher frequency range applies.
NOTE 2These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects, and people.
NOTE 3 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation
NOTE 4 - This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause
interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes: 1) L’appareil ne doit pas produire de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
NOTE 5 The fluid warmer wireless operation is safe and complies to RF exposure requirements.
NOTE 6 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE 7 - This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Proximity
Magnetic
Fields IEC
61000-4-39
65A/m (rms), PM at
2.1 kHz,
50% duty cycle,
134.2kHz;
7.5A/m (rms), PM at
50 kHz,
50% duty cycle,
13.56MHz
65A/m (rms), PM
at 2.1 kHz,
50% duty cycle,
134.2kHz;
7.5A/m (rms), PM
at 50 kHz,
50% duty cycle,
13.56MHz
Where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
a
should be less than the compliance level in
each frequency range.
b
Interference may occur in the vicinity of
equipment marked with the following symbol:
Table 3: Guidance and Manufacturer's Declaration - Electromagnetic Immunity