Page 23 of 51
EFW5L_IFU REV NEW
e. Insert Fuse Holders into CoreTemp and secure with Screwdriver.
6.6 Initial Setup
Follow the steps below for initial setup of the warmer system. All of the settings
referenced in this section will remain set when EFW5L is turned off and then turned
back on.
6.6.1 Temperature Scale Function
Temperature readings can be displayed in either Fahrenheit or Celsius.
Change the temperature scale as follows:
a. From the home screen, press the right arrow button to navigate to the Operations
menu. (“Display Units 1” will be selected in a red font.)
Figure 6: Fuse Installation
To Next Page
Loading...