Page 20 of 51
EFW5L_IFU REV NEW
6 Installation and Setup
All personnel using EFW5L should fully understand the Instructions for Use prior to
using the device. Review the instructions in this manual and become familiar with all
controls and functions before operating EFW5L in an operating room.
6.1 Locking/Unlocking the Wheels
Prior to first use, engage and disengage all three (3) wheel locks a total of five (5) times to
break in the locking mechanism.
Lock/Unlock the wheels as follows:
EFW5L has three wheels with Wheel Locks.
Lock the wheels by pressing down on the Wheel Locks until they remain in the
down position.
Unlock the wheels by lifting the Wheel Locks until they remain in the neutral
position.
Unlock the wheels before moving EFW5L, and make sure the wheels are locked once it is
in position.
6.2 Moving EFW5L
Move the unit as follows:
a. Remove fluid from EFW5L basin before moving.
b. Keep hold of the Handle on the EFW5L unit at all times during movement.
c. Be sure that the floor area near EFW5L is free from cables, cords, thresholds, or any
other obstructions.
d. Once EFW5L is in position, use the Wheel Locks to prevent any unintended
movement.
6.3 Height Adjustment Column Only
Refer to Figure 4. EFW5L can be raised or lowered as follows:
a. Lock the Wheel Locks (1) to prevent unintended movement of the unit during
adjustment.
b. Find the current location of the Height Adjustment Pin (2).
c. Hold the column with one handle and use the other hand to remove the pin.
d. Slide the column up or down until the pin hole lines up with the hole associated with
the desired height.
To Next Page
Loading...