Ecom ECP2010 - Page 37

ECP2010 / ECP2010H
37 / 68
Setting
Description
COPY
Copying program to following positions.
Press key ENTER to enter an item. Use cursor to set number of position
Y. EMPTY. Press ENTER again to start copying and this screen is
automatically left back to edited program X. S(xx).
Y. EMPTY changes to Y. S(xx).
DELETE
Deleting content of edited program.
After pressing ENTER a menu is displayed with a question, whether to
delete YES by pressing ENTER or NO by pressing ESC. After confirming
YES, we stay in currently edited program, then it is saved and
X. S(xx) changes to EMPTY.
Note: Steps with same time are lined in order, as they were created.
WORKING WITH STEPS IN MENU ITEM TIME TABLE
Action
Description
Adding new step
Use arrow down from last step.
Adding new step
between existing
steps
1) Create new step – start time of step, flowrate, concentration in % (see
table above).
2) Exit TIME TABLE – ESC.
3) Controlling alterations made – enter TIME TABLE. New step is enlisted
on its position in time axis of step beginnings.
Deleting step
1) Choose step X. for deletion.
2) Adjust start time of step – mm:ss to 00:00 – ENTER – step remains in
the list on the same position.
3) Exit TIME TABLE – ESC.
4) Controlling alterations made – enter TIME TABLE. Step X. is deleted.
Moving step
1) Choose step X. that should be moved.
2) Adjust start time of step X to desired time – ENTER – step remains in
the list on the same position.
3) Exit TIME TABLE – ESC.
4) Controlling alterations made – enter TIME TABLE. Step X. is moved to
its position in time axis of step beginnings.
Step change of
concentration
1) Create new step – start time of the step is equal to start time of
previous step. Value of flowrate remains the same or is different from
previous step. Enter desired concentration.
e.g.: A 100% changes to 0%, B 0% changes to 100%, C, D are closed.
2) Save.