Note: The console can store historical data on a memory card. This
memory card is not included. If you want to use one you will need
a microSD memory card. The supported max capacity of the card is
32G (Format: FAT32). A 1GB card will store more than 10 years’
data. There is also no requirement on the speed class of this card as
data writing happens infrequently and is not speed critical.
Note: Batteries for the ultrasonic anemometer and the rain gauge sensor
are not included. You will need 2 AA size Lithium battery for the
ultrasonic anemometer, which is primarily for startup and backup
purpose. After setup and during normal operation, the unit is getting
its power from solar cell. One AA size battery, alkaline or Lithium
(recommended for colder climates) is required for the rain gauge.
Two AA size alkaline batteries are required for the indoor sensor.
Note: There are two sets of U-bolts in the box, one is for the ultrasonic
anemometer sensor and the other one is for the rain gauge sensor.
There’s a short stainless-steel tube included for the rain gauge
sensor installation.
Note: The rain gauge can also be mounted to a surface using two screws,
so the included stainless-steel tube is not always necessary!
To Next Page
Loading...
