3 - 12 AG45134 Rev. 3
Loading Notch-registered plates
Step 1. Face the input tray.
Step 2. Raise the pinch roller bar to open the pinch rollers.
Be sure the pinch roller is fully raised. If it is not, the green
Expose LED will not light.
Step 3. Verify the requested pin bar is loaded. If it is not, change the pin
bar.
Step 4. Place the requested plate on the input tray.
Step 5. Position the plate so that both notches in the plate fully engage the
two registration pins on the pin bar (see Figure 3-8).
To Next Page
Loading...