4 - 4 AG45134 Rev. 3
Step 5. Pull the filter out of its slot.
Step 6. Wash the filter in mild, soapy water, rinse in clean water and dry.
Step 7. Place the filter back into the slot.
Step 8. Push the filter, from the outside, until it is completely in the
machine.
Step 9. From inside the pedestal, gently push the filter to the middle of the
machine until it is fully seated in the holder.
Step 10. Repeat steps 1 through 10 above for the other filter, which is
located on the opposite side of the system.
Cleaning the Media Drive Rollers
Cleaning the rollers will cut down on the contaminants running
through the media system. Dirty rollers can cause contamination of
the media.
Front Media Roller Cleaning Procedure
Cleaning the Drive Roller
Step 1. Open the pinch roller bar to open the rollers.
Step 2. Use the User Maintenance Menu to run the media rollers.
Step 3. Sparingly apply Fantastik (ECRM HB2456) to a clean, lint-free
wipe.
Step 4. As the rollers turn, gently wipe both the front and back rollers with
the cloth, being careful to not catch the cloth in the rollers. Do
not touch the rollers with bare hands. The oils and dirt will con-
taminate the rollers.
Step 5. After wiping with Fantastik, sparingly apply isopropyl alcohol to a
clean, lint-free wipe.
Step 6. As the rollers turn, gently wipe both the front and back rollers with
To Next Page
Loading...