EasyManuals Logo

EDAN INSTRUMENTS SA Series User Manual

EDAN INSTRUMENTS SA Series
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
SA Series Ambulatory Blood Pressure Monitor User Manual EMC Information
- 54 -
a) For some services, only the uplink frequencies are included.
b) The carrier shall be modulated using a 50% duty cycle square wave signal.
c) As an alternative FM modulation, 50% pulse modulation at 18 Hz may be used because while it
does not represent actual modulation, it would be worst case.
Recommended separation distances between portable and mobile RF communications
equipment and the EQUIPMENT or SYSTEM
Recommended separation distances between
portable and mobile RF communications equipment and the SA series device
The SA series device is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of the SA series device can help
prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the SA series device as recommended
below, according to the maximum output power of the communications equipment.
Maximum
output power
rating of
transmitter
(W)
Separation distance according to frequency of transmitter (m)
150 kHz to 80 MHz
Pd 2.1
80 MHz to 800 MHz
Pd 2.1
800 MHz to 2.7 GHz
Pd 3.2
0.01
0.12
0.12
0.23
0.1
0.38
0.38
0.73
1
1.2
1.2
2.3
10
3.8
3.8
7.3
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in metres (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range
applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EDAN INSTRUMENTS SA Series and is the answer not in the manual?

EDAN INSTRUMENTS SA Series Specifications

General IconGeneral
BrandEDAN INSTRUMENTS
ModelSA Series
CategoryBlood Pressure Monitor
LanguageEnglish