SE-12 Series Electrocardiograph User Manual Introduction
- 16 -
Press to enter the recovery phase. In the recovery phase, press this
key to enter the next stage of the recovery phase.
Press to display a pop-up dialog box, and then you can decide
whether the exercise test should be terminated.
Press to display the Input BP dialog box, and then enter the BP
values manually.
During the exercise test, press this key to review 10s data and print
out the 12-channel ECG report of the reviewed 10s data.
During the exercise test, press this key to sample 10s data and print
out the 12-channel ECG report of the sampled 10s data.
During the exercise test, press this key to print out the average
template report.
Press to display the Comment dialog box, and then you can annotate
in the dialog box. The annotations will be displayed in the summary
report.
Press Speed Load +/- to change the speed of the treadmill during the
exercise phase.
Press Speed Load +/- to change the power of the ergometer during
the exercise phase.
NOTE: The two keys are available for the customized protocol only.
Press Grade +/- to change the grade of the treadmill during the
exercise phase.
NOTE: The two keys are available for the customized protocol only.
Before the exercise test, press the Start tmill key to test the
connection between the electrocardiograph and the treadmill, and
then press the Stop tmill key to stop the connection test.
During the exercise test, press the Stop tmill key to stop the test
temporarily, and then press the Start tmill key to restart the test.
NOTE: Pressing the Stop tmill key cannot add the timing of the
current phase during the exercise test.
Press to select menu functions on the screen.
To Next Page
Loading...
