Need help?Do you have a question about the Eddyfi Technologies INUKTUN VERSATRAX 100 and is the answer not in the manual?
General| Category | Robotics |
|---|---|
| Manufacturer | Eddyfi Technologies |
| Model | INUKTUN VERSATRAX 100 |
| IP Rating | IP68 |
| Material | Aluminum and stainless steel |
| Communication | Tethered |
Details the roles and responsibilities of personnel involved in system deployment and operation.
Specifies the environmental conditions suitable for operating and storing the control system and vehicle.
Details the voltage and frequency requirements for operating the Versatrax 100TM system.
Provides guidance on using generators or inverters to power the system, including load rating considerations.
Explains how the ICON Portable Controller connects to and powers the tether and vehicle.
Details how to configure the vehicle in parallel mode, including track angle adjustments.
Explains how to adjust the track angle for different pipe diameters in parallel configuration.
Details the extended parallel chassis for accommodating weights, magnets, and the SP90 camera.
Instructions for assembling the tracks onto the side plates and hinges in the inline configuration.
Steps for installing the rear camera module, including O-ring inspection and lens adjustment.
Essential checks to perform before deploying the Versatrax 100TM system for operation.
Diagnosing and resolving issues related to camera lights, pan, tilt, and movement speed.
Procedures for cleaning the vehicle after use, including precautions against pressure washing.
Instructions and precautions for replacing fuses in the controller and power supply.
Information on how to order spare parts and contact customer service for Eddyfi Technologies.
Details specific conditions and items not covered by the limited warranty policy.
To Next Page