Configuring the Switch
3-80
3
• Flow control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port Security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address that can be
learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security violation is
detected. (shutdown, trap, trap-and-shutdown)
• Combo forced mode – Shows the forced/preferred port type to use for
combination ports
9-12. (copper forced, copper preferred auto, SFP forced, SFP
preferred auto)
Current status:
• Link Status – Indicates if the link is up or down.
• Operation speed-duplex – Shows the current speed and duplex mode.
• Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5 4-157
Information of Eth 1/13
Basic information:
Port type: 1000T
Mac address: 00-30-f1-47-58-46
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full, 1000full,
Broadcast storm: Enabled
Broadcast storm limit: 500 packets/second
Flow control: Disabled
Lacp: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Combo forced mode: None
Current status:
Link status: Down
Operation speed-duplex: 100full
Flow control type: None
Console#
To Next Page
Loading...
