Edge-Core ES4612 - DHCP Server; Service Dhcp; Table 4-46 DHCP Server Commands

Command Line Interface
4-130
4
DHCP Server
service dhcp
This command enables the DHCP server on this switch. Use the no form to disable
the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
If the DHCP server is running, you must restart it to implement any
configuration changes.
Table 4-46 DHCP Server Commands
Command Function Mode Page
service dhcp Enables the DHCP server feature on this switch GC 4-130
ip dhcp
excluded-address
Specifies IP addresses that a DHCP server should not assign to
DHCP clients
GC 4-131
ip dhcp pool Configures a DHCP address pool on a DHCP Server GC 4-131
network Configures the subnet number and mask for a DHCP address pool DC 4-132
default-router Specifies the default router list for a DHCP client DC 4-133
domain-name Specifies the domain name for a DHCP client DC 4-133
dns-server Specifies the Domain Name Server (DNS) servers available to a
DHCP client
DC 4-134
next-server Configures the next server in the boot process of a DHCP client DC 4-134
bootfile Specifies a default boot image for a DHCP client DC 4-135
netbios-name-server Configures NetBIOS Windows Internet Naming Service (WINS)
name servers available to Microsoft DHCP clients
DC 4-135
netbios-node-type Configures NetBIOS node type for Microsoft DHCP clients DC 4-136
lease Sets the duration an IP address is assigned to a DHCP client DC 4-136
host* Specifies the IP address and network mask to manually bind to a
DHCP client
DC 4-137
client-identifier* Specifies a client identifier for a DHCP client DC 4-138
hardware-address* Specifies the hardware address of a DHCP client DC 4-139
clear ip dhcp binding Deletes an automatic address binding from the DHCP server
database
PE 4-139
show ip dhcp binding Displays address bindings on the DHCP server PE, NE 4-140
*These commands are used for manually binding an address to a client.