EasyManua.ls Logo

Edge-Core ES4612 - Open Shortest Path First (OSPF); Table 4-85 Open Shortest Path First Commands

Edge-Core ES4612
666 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Routing Commands
4-259
4
Open Shortest Path First (OSPF)
Table 4-85 Open Shortest Path First Commands
Command Function Mode Page
General Configuration
router ospf Enables or disables OSPF GC 4-260
router-id Sets the router ID for this device RC 4-260
compatible rfc1583 Calculates summary route costs using RFC 1583 (OSPFv1) RC 4-261
default-information
originate
Generates a default external route into an autonomous system RC 4-262
timers spf Configures the hold time between consecutive SPF calculations RC 4-263
Route Metrics and Summaries
area range Summarizes routes advertised by an ABR RC 4-264
area default-cost
Sets the cost for a default summary route sent into a stub or NSSA
RC 4-264
summary-address Summarizes routes advertised by an ASBR RC 4-265
redistribute Redistribute routes from one routing domain to another RC 4-266
Area Configuration
network area Assigns specified interface to an area RC 4-267
area stub Defines a stubby area that cannot send or receive LSAs RC 4-268
area nssa Defines a not-so-stubby that can import external routes RC 4-269
area virtual-link Defines a virtual link from an area border routers to the backbone RC 4-270
Interface Configuration
ip ospf authentication Specifies the authentication type for an interface IC 4-272
ip ospf authentication-key
Assigns a simple password to be used by neighboring routers IC 4-273
ip ospf
message-digest-key
Enables MD5 authentication and sets the key for an interface IC 4-274
ip ospf cost Specifies the cost of sending a packet on an interface IC 4-275
ip ospf dead-interval Sets the interval at which hello packets are not seen before
neighbors declare the router down
IC 4-275
ip ospf hello-interval Specifies the interval between sending hello packets IC 4-276
ip ospf priority Sets the router priority used to determine the designated router IC 4-276
ip ospf retransmit-interval
Specifies the time between resending a link-state advertisement IC 4-277
ip ospf transmit-delay
Estimates time to send a link-state update packet over an interface
IC 4-278
Display Information
show ip ospf Displays general information about the routing processes PE 4-278
show ip ospf
border-routers
Displays routing table entries for Area Border Routers (ABR) and
Autonomous System Boundary Routers (ASBR)
PE 4-279
show ip ospf database Shows information about different LSAs in the database PE 4-280
show ip ospf interface Displays interface information PE 4-288
show ip ospf neighbor Displays neighbor information PE 4-289

Table of Contents

Related product manuals