Edge-Core ES4612 - Figure 3-49 Port - Port Configuration

Configuring the Switch
3-82
3
Note: Auto-negotiation must be disabled before you can configure or force the interface
to use the Speed/Duplex Mode or Flow Control options.
Web – Click Port, Port Configuration or Trunk Configuration. Modify the required
interface settings, and click Apply.
Figure 3-49 Port - Port Configuration
CLI – Select the interface, and then enter the required settings.
Console(config)#interface ethernet 1/13 4-149
Console(config-if)#description RD SW#13 4-150
Console(config-if)#shutdown 4-154
.
Console(config-if)#no shutdown
Console(config-if)#no negotiation 4-151
Console(config-if)#speed-duplex 100half 4-150
Console(config-if)#flowcontrol 4-153
.
Console(config-if)#negotiation
Console(config-if)#capabilities 100half 4-152
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#exit
Console(config)#interface ethernet 1/21
Console(config-if)#combo-forced-mode copper-forced 4-154
Console(config-if)#