Edge-Core ES4612 - Snmp-Server Host

SNMP Commands
4-117
4
snmp-server host
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the no form to remove the specified host.
Syntax
snmp-server host host-addr community-string
[version {1 | 2c | 3 {auth | noauth | priv}} [udp-port port]]
no snmp-server host host-addr
• host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can set this
string using the snmp-server host command by itself, we recommend that
you define this string using the snmp-server community command prior
to using the snmp-server host command. (Maximum length: 32
characters)
• version - Specifies whether to send notifications as SNMP Version 1, 2c or
3 traps.
• auth | noauth | priv - This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See “Simple Network
Management Protocol” on page 3-35 for further information about these
authentication and encryption options.
• port - Host UDP port to use. (Range: 1-65535; Default: 162)
Default Setting
Host Address: None
SNMP Version: 1
UDP Port: 162
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server host command, no notifications are sent.
In order to configure the switch to send SNMP notifications, you must enter at
least one snmp-server host command. In order to enable multiple hosts, you
must issue a separate snmp-server host command for each host.
•The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable traps
command to specify which SNMP notifications are sent globally. For a host to
receive notifications, at least one snmp-server enable traps command and
the snmp-server host command for that host must be enabled.
• Some notification types cannot be controlled with the snmp-server enable
traps
command. For example, some notification types are always enabled.
• The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
address, depending on the SNMP version that the management station