Edge-Core ES4612 - Dot1 X Timeout Re-Authperiod; Dot1 X Timeout Tx-Period

Command Line Interface
4-84
4
dot1x timeout re-authperiod
This command sets the time period after which a connected client must be
re-authenticated.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Global Configuration
Example
dot1x timeout tx-period
This command sets the time that the switch waits during an authentication session
before re-transmitting an EAP packet. Use the no form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Global Configuration
Example
Console(config)#dot1x timeout re-authperiod 300
Console(config)#
Console(config)#dot1x timeout tx-period 300
Console(config)#