Edge-Core ES4612 - Map Ip Port (Global Configuration); Priority Commands (Layer 3 and 4); Table 4-66 Priority Commands (Layer 3 and 4)

Priority Commands
4-213
4
Example
Priority Commands (Layer 3 and 4)
map ip port (Global Configuration)
Use this command to enable IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
CoS Value : 0 1 2 3 4 5 6 7
Priority Queue: 2 0 1 3 4 5 6 7
Console#
Table 4-66 Priority Commands (Layer 3 and 4)
Command Function Mode Page
map ip port Enables TCP/UDP class of service mapping GC 4-213
map ip port Maps TCP/UDP socket to a class of service IC 4-214
map ip precedence Enables IP precedence class of service mapping GC 4-214
map ip precedence Maps IP precedence value to a class of service IC 4-215
map ip dscp Enables IP DSCP class of service mapping GC 4-216
map ip dscp Maps IP DSCP value to a class of service IC 4-216
map access-list ip Sets the CoS value and corresponding output queue for
packets matching an ACL rule
IC 4-99
map access-list mac Sets the CoS value and corresponding output queue for
packets matching an ACL rule
IC 4-109
show map ip port Shows the IP port map PE 4-217
show map ip precedence Shows the IP precedence map PE 4-218
show map ip dscp Shows the IP DSCP map PE 4-219
show map access-list ip Shows CoS value mapped to an access list for an interface PE 4-100
show map access-list mac Shows CoS value mapped to an access list for an interface PE 4-110