Access Control List Commands
4-105
4
Example
Related Commands
permit, deny 4-103
mac access-group (4-108)
access-list mac mask-precedence
This command changes to MAC Mask mode used to configure access control
masks. Use the no form to delete the mask table.
Syntax
[no] access-list ip mask-precedence {in | out}
• in – Ingress mask for ingress ACLs.
• out – Egress mask for egress ACLs.
Default Setting
Default system mask: Filter inbound packets according to specified MAC ACLs.
Command Mode
Global Configuration
Command Usage
• You must configure a mask for an ACL rule before you can bind it to a port or
set the queue or frame priorities associated with the rule.
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined by
order of the rules, but instead by the order of the masks; i.e., the first mask
that matches a rule will determine the rule that is applied to a packet.
Example
Related Commands
mask (MAC ACL) (4-106)
mac access-group (4-108)
Console#show mac access-list
MAC access-list jerry:
permit any 00-e0-29-94-34-de ethertype 0800
Console#
Console(config)#access-list mac mask-precedence in
Console(config-mac-mask-acl)#
To Next Page
Loading...
