Command Line Interface
4-248
4
show ip traffic
This command displays statistics for IP, ICMP, UDP, TCP and ARP protocols.
Command Mode
Privileged Exec
Command Usage
For a description of the information shown by this command, see “Displaying
Statistics for IP Protocols” on page 3-205.
Example
Routing Information Protocol (RIP)
Console#show ip traffic
IP statistics:
Rcvd: 5 total, 5 local destination
0 checksum errors
0 unknown protocol, 0 not a gateway
Frags: 0 reassembled, 0 timeouts
0 fragmented, 0 couldn't fragment
Sent: 9 generated
0 no route
ICMP statistics:
Rcvd: 0 checksum errors, 0 redirects, 0 unreachable, 0 echo
5 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp
Sent: 0 redirects, 0 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 time exceeded, 0 parameter problem
UDP statistics:
Rcvd: 0 total, 0 checksum errors, 0 no port
Sent: 0 total
TCP statistics:
Rcvd: 0 total, 0 checksum errors
Sent: 0 total
ARP statistics:
Rcvd: 0 requests, 1 replies
Sent: 1 requests, 0 replies
Console#
Table 4-82 Routing Information Protocol Commands
Command Function Mode Page
router rip Enables the RIP routing protocol GC 4-249
timers basic Sets basic timers, including update, timeout, garbage collection RC 4-249
network Specifies the network interfaces that are to use RIP routing RC 4-250
neighbor Defines a neighboring router with which to exchange information RC 4-251
version Specifies the RIP version to use on all network interfaces (if not
already specified with a receive version or send version command)
RC 4-252
ip rip receive version Sets the RIP receive version to use on a network interface IC 4-253
ip rip send version Sets the RIP send version to use on a network interface IC 4-254
ip split-horizon Enables split-horizon or poison-reverse loop prevention IC 4-255
To Next Page
Loading...
