Edge-Core ES4612 - Media-Type; Shutdown

Command Line Interface
4-154
4
Example
The following example enables flow control on port 5.
Related Commands
negotiation (4-151)
capabilities (flowcontrol, symmetric) (4-152)
media-type
This command forces the port type selected for combination ports 8 - 12. Use the no
form to restore the default mode.
Syntax
media-type mode
no media-type
• mode
- copper-forced - Always uses the built-in RJ-45 port.
- copper-preferred-auto - Uses the built-in RJ-45 port if both combination
types are functioning and the RJ-45 port has a valid link.
- sfp-forced - Always uses the SFP port (even if module not installed).
- sfp-preferred-auto - Uses SFP port if both combination types are
functioning and the SFP port has a valid link.
Default Setting
sfp-preferred-auto
Command Mode
Interface Configuration (Ethernet)
Example
This forces the switch to use the built-in RJ-45 port for the combination port 8.
shutdown
This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
Console(config)#interface ethernet 1/8
Console(config-if)#media-type copper-forced
Console(config-if)#