Configuring the Switch
3-10
3
Interface Configuration Shows area ID and designated router; also configures OSPF
protocol settings and authentication for each interface
3-232
Virtual Link Configuration Configures a virtual link through a transit area to the backbone 3-236
Network Area Address
Configuration
Defines OSPF areas and associated interfaces 3-238
Summary Address
Configuration
Aggregates routes learned from other protocols for advertising
into other autonomous systems
3-241
Redistribute Configuration Redistributes routes from one routing domain to another 3-242
NSSA Settings Configures settings for importing routes into or exporting routes
out of not-so-stubby areas
3-243
Link State Database
Information
Shows information about different OSPF Link State
Advertisements (LSAs) stored in this router’s database
3-245
Border Router Information Displays routing table entries for area border routers and
autonomous system boundary routers
3-247
Neighbor Information Displays information about neighboring routers on each
interface within an OSPF area
3-248
DVMRP 3-253
General Settings Configure global settings for prune and graft messages, and the
exchange of routing information
3-253
Interface Settings Enables/disables DVMRP per interface and sets the route metric 3-256
Neighbor Information Displays neighboring DVMRP routers 3-258
Routing Table Displays DVMRP routing information 3-259
PIM-DM
General Settings Enables or disables PIM-DM globally for the switch 3-260
Interface Settings Enables or disables PIM-DM per interface, configures protocol
settings for hello, prune and graft messages
3-261
Interface Information Displays summary information for each interface 3-264
Neighbor Information Displays neighboring PIM-DM routers 3-264
Table 3-2 Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
